ezcurrent.c

Go to the documentation of this file.

#include "sensors/ezcurrent.h"
#include "mcu_periph/i2c.h"
#include "subsystems/electrical.h"

#define EZCURRENT_ADDR 0xEF

#ifndef EZCURRENT_I2C_DEV
#define EZCURRENT_I2C_DEV i2c1
#endif

struct i2c_transaction ezcurrent_i2c_trans;

void ezcurrent_init(void)
{
  electrical.vsupply = 0;
  electrical.current = 0;

  ezcurrent_i2c_trans.status = I2CTransDone;
  ezcurrent_i2c_trans.slave_addr = EZCURRENT_ADDR;
}

void ezcurrent_read_periodic(void)
{
  if (ezcurrent_i2c_trans.status == I2CTransDone) {
    i2c_receive(&EZCURRENT_I2C_DEV, &ezcurrent_i2c_trans, ezcurrent_i2c_trans.slave_addr, 10);
  }
}

#define Uint16FromBuf(_buf,_idx) ((uint16_t)((_buf[_idx+1]<<8) | _buf[_idx]))
#define Int16FromBuf(_buf,_idx) ((int16_t)((_buf[_idx+1]<<8) | _buf[_idx]))

void ezcurrent_read_event(void)
{
  if (ezcurrent_i2c_trans.status == I2CTransSuccess) {
    /* voltage of EzOSD sensor is provided in mV, convert to deciVolt */
    electrical.vsupply = Uint16FromBuf(ezcurrent_i2c_trans.buf, 2) / 100;
    /* consumed ? in mAh */
    electrical.consumed = Int16FromBuf(ezcurrent_i2c_trans.buf, 6);
    /* sensor provides current in 1e-1 Ampere, convert to mA */
    electrical.current = Int16FromBuf(ezcurrent_i2c_trans.buf, 8) * 100;

    // Transaction has been read
    ezcurrent_i2c_trans.status = I2CTransDone;
  } else if (ezcurrent_i2c_trans.status == I2CTransFailed) {
    ezcurrent_i2c_trans.status = I2CTransDone;
    // ezcurrent_i2c_trans.slave_addr++;
  }
}