Example for airframe file

Add to your firmware section: This example contains all possible configuration options, not all of them are mandatory!

 <module name="temp_temod">
   <define name="TEMOD_TYPE" value="type" />
   <define name="TEMOD_SDLOG" value="TRUE|FALSE" />
   <configure name="TEMOD_I2C_DEV" value="i2cX" />
 </module>

Module configuration options

Configure Options

name: TEMOD_I2C_DEV value: i2cX
Description: select i2c peripheral to use (default i2c0)

Define Options

name: TEMOD_TYPE value: type
Description: device type (default TEMOD_I2C_R1)
name: TEMOD_SDLOG value: TRUE|FALSE
Description: start logging to SD card

Module functions

Init Functions

These initialization functions are called once on startup.

temod_init()

Event Functions

These event functions are called in each cycle of the module event loop.

temod_event()

Periodic Functions

These functions are called periodically at the specified frequency from the module periodic loop.

temod_periodic()
- Frequency in Hz: 8
- Autorun: LOCK
  Periodic function automatically starts after init and can't be stopped.

Files

Header Files

The following headers are automatically included in modules.h

temp_temod.h

Source Files

modules/meteo/temp_temod.c

Raw temp_temod.xml file:

<!DOCTYPE module SYSTEM "module.dtd">
<module name="temp_temod" dir="meteo">
  <doc>
    <description>Hygrosens TEMOD-I2C-Rx temperature sensor</description>
    <configure name="TEMOD_I2C_DEV" value="i2cX" description="select i2c peripheral to use (default i2c0)"/>
    <define name="TEMOD_TYPE" value="type" description="device type (default TEMOD_I2C_R1)"/>
    <define name="TEMOD_SDLOG" value="TRUE|FALSE" description="start logging to SD card"/>
  </doc>
  <header>
    <file name="temp_temod.h"/>
  </header>
  <init fun="temod_init()"/>
  <periodic fun="temod_periodic()" freq="8"/>
  <event fun="temod_event()"/>
  <makefile target="ap">
    <configure name="TEMOD_I2C_DEV" default="i2c0" case="upper|lower"/>
    <define name="USE_$(TEMOD_I2C_DEV_UPPER)"/>
    <define name="TEMOD_I2C_DEV" value="$(TEMOD_I2C_DEV_LOWER)"/>
    <file name="temp_temod.c"/>
  </makefile>
</module>